DC-5KHz Driver for Standard NanoSpeed™ Switches

The NS Switch driver provides driving signals for the NS series solid state switches. The push-pull output design ensures fast switching time for both rising and falling edges, and it is especially suitable for driving capacitive loads. The standard driver controls one individual switch. Drivers that control multiple switches also are available. It has a built-in protector (LED flash) against higher repetition rate over 5MHz and can be reset by restarting the power.

DC-5KHz Driver for Standard NanoSpeed™ Switches

The NS Switch driver provides driving signals for the NS series solid state switches. The push-pull output design ensures fast switching time for both rising and falling edges, and it is especially suitable for driving capacitive loads. The standard driver controls one individual switch. Drivers that control multiple switches also are available. It has a built-in protector (LED flash) against higher repetition rate over 5MHz and can be reset by restarting the power.
  Specs Min Typical Max Unit
Rise Time (Tr)[1]   85 100 ns
Fall Time (Tf)[2]   85 100 ns
Switch Speed (Rise) (Sr) [3]   200 250 ns
Switch Speed (Fall) (Sf) [3]   200 250 ns
Repetition Rate[4] DC   5 kHz
Pulse Width 1.0     us
Control Input 0   5 V
Power Consumption 0.6   3 W
Power Supply   12   V
Operating Temperature -5   70 ºC
Storage Temperature -40   80 ºC
Electrical Connector SMA
Board Size 2.8(W)x2.0(D)x1(H) Inch

Note:

[1]: Optic Intensity Change from 10% to 90% intuits;

[2]: Optic Intensity Change from 90% to 10% intuits;

[3]: Including electronic signal delay;

[4]: When the repetition rate is > 5kHz, an alarm LED will be flashing. Restart DC power to release this protection.

 

Question Title:

Please summarize your question

Your Question:
Your Name:

Tell us your name